SMC Pipeline – Two Characteristics to Take Into Consideration if Looking Into Acquiring SMC Pipelines.

Pipeline and pipe inspection is a crucial service presented to many industries, often oil, gas, chemical and power. The key function of SMC manufacturer inspection is always to maintain and increase the integrity in the plant or system, to stop failures, ensure safety standards, avoid accidents, abide by government laws and save time and cash.

Pipeline and pipe Inspection uses NDT (Non Destructive Testing) methods to undertake inspections, using highly trained personal often performing a number of methods to determine variety of flaws, size, type and likelihood of each. Results are summarised in the report with appropriate graphs and technical drawings to illustrate the a summary of your results after careful analysis by a trained technician.

Several various kinds of piping could be inspected, several of the main types include;

Above ground non insulated piping

Long pipeline runs

Short underground runs

Service Water systems in nuclear plants

Fire protection systems in nuclear plants

The Low Frequency Electromagnetic Technique (LFET) is often used because of its highly flexible nature. For rapid identification of total flaws, a piece of kit for example the PS-2000 works extremely well, though it may also be put into screening mode to provide more descriptive information, which can then be proved up via another technique say for example a-Scan Ultrasonics.

For extended pipelines equipment for example the LineCat excels. The LineCat is ideally suitable for long pipeline inspection, due to its shape, and its particular self-propulsion. The LineCat can be a rig that wraps throughout the OD (Outer Diameter) of the pipeline, propelling itself at 10 ft/minute. The LineCat uses the LFET technique just as the PS-2000 above, however due to the rapid independent nature, makes SMC pipeline hassle free, compared to a other systems that need manual movement via an operator.

In nuclear plants the main concerns of piping inspections are service water system piping and fire protection system piping. These are generally inspected to quantify MIC (Micro-biologically induced corrosion) and FAC (Flow accelerated corrosion).

For shorter underground piping runs, equipment including the Eagle-2000 system may be utilised. The Eagle-2000 uses SMC alu pipe, and performs inspections 17dexypky the ID (Inner Diameter), picking up on small flaws due to the high res and small sensor size. It could provide realtime 3d data to analyse flaws live, and inspects through scale.

During inspection exactly the same forms of flaws usually arise, attack by external and internal corrosion are typical, and also cracking, though 3rd party damage is one of the main culprit for many of the major flaws. Flaws caused in the manufacturing process may be found on also, though they’re generally rare ahead across.